Electrical power UNITS FOR LIFT TABLE

Power UNITS FOR LIFT TABLE one
General Description
This power unit is developed exclusively for the small lift table,Consisting of large pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This energy unit continues to be widely employed within the industry of logistic gadgets for example minifork lift, scissors lift and ariel working platforms. The lower-ing movement is managed through the solenoid valve using the pace managed from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Standard Description
This power unit is created exclusively for the medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve as well as the velocity managed through the adjustable needle valve. Once the lift rises to a higher positoin, but the electrical power provide is minimize, the reducing movement is managed through the manual override perform.
Electrical power UNITS FOR LIFT TABLE 3
Standard Description
This energy unit is created exclusively for your massive lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve as well as the speed controlled by a stress compensated movement manage valve.
Electrical power UNITS FOR LIFT TABLE 4
Standard Description
This electrical power unit is made exclusively for that massive lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve along with the speed controlled from the adjustable needle valve. Once the lift rises to a high positoin, but the energy supply is reduce, the lowering movement is managed from the manual override function.
Exclusive Notes
one. This power unit is of S3 duty cycle, which might only work intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean all of the hydraulic components concerned ahead of installation of the power unit.
3. Viscosity in the oil shoud be 15~46 cst,which ought to also be clean and no cost of impurities.N46 hydraulic oil is suggested.
four. Oil transforming is required following the original one hundred operation hrs,afterwards after every single 3000 hrs.
five. The energy unit proven is designed to be mounted vertically.